What do I need to do to my ReefBot if it has not been used for more than 10 days?

Created by Reef Kinetics, Modified on Tue, 27 Dec 2022 at 01:02 PM by Reef Kinetics

1- Put the "Tank" tube in RODI

2- Run any test

3- When done, remove "Tank" and "RODI" tubes and run a test without any water

4- Remove all the tubes from the bulkheads

5- Drain the tubes

6- Store the device in a dry place with no direct sunlight or heat source

7- Unclog the valve. Please do the following:

- Open the back cover of the device (using the 2.5mm Allen Key provided)

- Lastly please unplug the hoses connected to the valve and repeat the process as in the video attached.

- When pushing inside the valve you should feel a spring-like mechanism opening and closing. Repeat this until you feel the valve is cleared and opening smoothly.

https://www.youtube.com/watch?v=GDf1nIuARbo

8- Check visually for any rust, get rid of it using wd-40 or any antirust detergent