1. It is possible to mount the device directly on a wall, or just let it stand on a flat surface.
2. The height difference between the Reefbot and the water surface level from where the Device will suck the water for testing, should not exceed 70 cm.
3. Make sure that if you adjust the device position, you recalibrate the pumps, as the delivery amount of fluids might vary based on the suction heights.
4. Hoses running from tank/RO containers should be as vertical as possible. Reduce as much horizontal length as possible.
5. It is strongly recommended to have as short length for hoses as possible
6. Make sure the water is moving upwards in the hose from the tank/RO water. Make sure there are no air bubbles anywhere in the hose.
7. If you have a filter on the sample intake hose, always check that it does not contain a high amount of debris or is partially clogged. Otherwise, you are kindly requested to replace the filter with a new one.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article